STRIKE INDUSTRIES Strike AR Mil-Spec Buffer Housing BLU

The Strike Industries AR Mil-Spec Buffer Housing gives the user a cost-effective means of customization while retaining functionality. The AR-15 buffer is often an overlooked part of the gas system that is needed to properly fine-tune your specific setup. This buffer housing is machined from 6061-T6 aluminum and designed to fit Mil-Spec standard or carbine length receiver extensions/buffer tubes while also providing a level of customization. The SI AR Mil-Spec Buffer Housing is shipped without weights so that you can either replace your current housing, use existing weights or opt to purchase weights to refine the weapons gas system to your specific needs. The NBR rubber material buffer pad helps absorb impact and is secured by the included roll pin. By modulating the weight through the combination of tungsten, steel and aluminum weights, the user is given a cost-effective means of adjusting the weapons reciprocating mass, and thus the recoil experienced by the shooter with the Strike Industries AR Mil-Spec Buffer Housing.

COMPATIBILITY:
-14mm (0.55") diameter Mil-Spec buffer weights and spacers (maximum of 14.20mm)
-Mil-Spec standard and carbine length receiver extensions/buffers

NOTE:
-Buffer housing only, no weights or spacers included
-Due to numerous factors that take place during the anodization process, the color lines from batch to batch of a certain product may vary

-LENGTH: 83.15 (with buffer pad)
-WIDTH: 25.25mm (curve to curve)
-HEIGHT: 24mm (flat to curved)
-WEIGHT: 1.0 oz
-WEIGHT W/ PKG: 1.2 oz

MADE IN THE USA

Druckfehler und Änderungen vorbehalten. Unsere Produktfotos und Artikelbeschreibungen sind urheberrechtlich geschützt. Eine Weiterverwendung ohne unsere Zustimmung stellt eine Urheberrechtsverletzung laut § 86 UrhG. dar.